What are the Slant 3D Print Service Settings

Hello Everyone

In order to produce thousands of parts per day with the consistency we need every part is made with Nearly identical print settings.

They are shown below

These are the high level print settings. But our system will intelligently adjust some settings to make sure you get the best result.

Seam - Seam may adjust between rear and aligned based on the surfaces of the part. For example a cylinder will have it at the rear and a cube would have it aligned at a corner.

Orientation - Parts will be aligned if they are obviously uploaded in a bad orientation. But we attempt to default to the orientation uploaded to not change designer intent.

Support - Support increasingly is determined by the system. But if you absolutely require support of designed support removal it must be flagged as on.

Main Print Parameter: -0.4 mm Nozzle -220x220x220 standard build volume -Textured Bed

If you require customization of these settings (different infill settings, etc) This is always on a case by case basis. But custom projects generally require a $5000 minimum project size.